Project SL Stereo Installation Day 2
iForged Project SL Audio Build
Stereo Project Countdown.
Full CES build in 11 Days
Installer: Frank Sbrocca and his team at Traffic Jams in North Hollywood, CA.
http://www.diamondaudio.com/
http://fiercecaraudio.com/
http://www.kenwoodusa.com/
Day 2 has been all about the amp and wiring display. Here Is the base for the wiring display
Once the base is made the caps and distribution blocks are laid out
After that we made a template of the floor to cover over the wiring. This panel will have a cutout that will show the wiring display
The upper panel will support the amplifiers. Here is another in progress picture as we line up the equipment
Here we have drilled all the holes for the wiring getting the panel ready to laminate
Once laminated we will start mounting all the wiring blocks and capacitors. It’s now time to wit up the blocks before put the panel in the car.
Here we are wiring the caps and. Distribution blocks.
Here is the display sitting in the car finished.
Here is the trim panel over the display
Here is the amp board with the laminate cut to fit.
Here is the amp board with the laminate cut to fit.
Frames are made around the outside edge of the panel to support the upper trim which will trim off the amplifiers and our wiring display
Our template for our bottom panel is now the base for our top trim also. With a few sizing modifications we will use the old template to now make the outside shape of our upper trim panel
Popularity: 9% [?]
